Hey everyone,
I’m trying to set up Marlin firmware for my 3D printer, but I’m running into some issues and could use some guidance. I’m using the Marlin Firmware Builder tool with machine learning , but I’m not sure if I’m configuring everything correctly.
Here’s my setup:
Printer Model: [Insert Printer Model]
Board: [Insert Controller Board]
Stepper Drivers: [Insert Driver Model]
Display Type: [Insert Display Model]
I’m particularly struggling with:
Bed Leveling Configuration – Not certain what the best method for my setup would be (ABL, Bilinear, UBL, etc.).
Stepper Motor Direction – Some motors are incorrect after flashing. What is the best way to correct?
EEPROM Settings – Should I turn EEPROM on or just use default settings?
If anyone has had experience with a similar setup or can walk me through the proper firmware settings, I’d greatly appreciate it! Thank you in advance.
Looking forward to your suggestions!
Regards
william8